Product Description
Description
60W Class D Mixer Amplifier, with 4 phoenix mic input, 2 Aux,100V &
4-16Ω output, built-in 24VDC
Do not expose the unit to rain or an environment where it may be splashed by water or other liquids, as doing so may result in fire or electric shock.
Use the unit only with the voltage specified on the unit. Using a voltage higher than that which is specified may result in fire or electric shock.
Do not cut, kink, otherwise damage nor modify the power supply cord. In addition, avoid using the power cord in close proximity to heaters, and never place heavy objects — including the unit itself — on the power cord, as doing so may result in fire or electric shock.
Be sure to replace the unit’s terminal cover after connection completion. Because high voltage is applied to the speaker terminals, never touch these terminals to avoid electric shock.
Be sure to ground to the safety ground (earth) terminal to avoid electric shock. Never ground to a gas pipe as a catastrophic disaster may result.
Avoid installing or mounting the unit in unstable locations, such as on a rickety table or a slanted surface. Doing so may result in the unit falling down, causing personal injury and/or property damage.
Product Usage Instructions
Ensure that the unit is installed and connected properly according to the instructions in the user manual.
Power on the unit using the ON/OFF switch.
To pair a Bluetooth device, follow these steps:
Press the PAIRED BLUETOOTH button on the front panel.
Enable Bluetooth on your device and search for available devices.
Select “ECA-70MIXAMP-1-240D” from the list of available devices.
Once connected, the Bluetooth indicator on the front panel will light up.
To use a microphone, connect it to one of the MIC inputs (MIC 1-4) using an appropriate cable.
Adjust the volume levels for each input channel using the corresponding knobs labeled 0-10.
If using an auxiliary device, connect it to one of the AUX inputs (AUX 1-2) using an appropriate cable.
Adjust the bass and treble levels using the BASS and TREBLE knobs.
Control the overall volume of the system using the MASTER volume knob.
Observe the CLIP SIG indicator to ensure that the audio signal is not being clipped or distorted. Adjust the volume levels accordingly.
Ensure that the PROT 70V switch is set to the appropriate voltage for your system (4-16).
When finished using the unit, power it off using the ON/OFF switch.
Similar Products
